Finally, somewhere to put your drink that isn't the felt.
4.9 from 119 Steadi reviewsA flexible-finned base that resists tipping on the rail, the racetrack, the couch arm, or the carpet — wherever this room already tells you a drink can't go.
Save the felt — from $14.95Doesn't touch the felt. Doesn't clamp. 90 days to prove it.
Will your tallboy fit the rail? A sticky note answers it — the test is below ↓
The setup
Every game in this room already told you where the drink can't go.
A pool table doesn't come with a coaster. A poker table's built-in cup holder was sized for one kind of drink. You can finish a basement top to bottom and still not have an honest place to set anything down.
The wooden lip around the felt is the only ledge within a shooter's reach, and it's the one surface every house rule bans a drink from — a sweating can rings the finish, and one bridge-hand bump sends it onto cloth that a spill stiffens for good. Refelting a table runs into the hundreds of dollars, and billiards guides name spills as the single most common reason it has to happen.
Poker tables built with drinks in mind still get it wrong — the recessed holder ringing the felt is shallow enough that a full glass goes over anyway, and the two sizes it comes in split the room: a standard cutout takes a can but not a rocks glass, a jumbo one lets a can rattle loose.
Every standing game — darts, pool, foosball — ties up both hands and leaves the drink at ankle height, invisible from standing height and sitting exactly where the next lunge for a shot puts a foot.
Hands stay on the controller for hours at a stretch, so the drink gets wedged between cushion and armrest. A clutch moment means sudden movement, and a tilted cushion does the rest — onto the cushion, or onto whatever's charging on the floor below.
Foosball rods slam and an air hockey table vibrates under its own blower, so a can set on the edge walks toward the corner on its own — parked directly above the electronics and directly under the elbows, right when the game gets heated.
None of it ends a game night on its own. But run enough rounds and one of these is where the spill actually happens — the felt, the carpet, or the cabinet edge.
Instant answer
Check the fit before you rack 'em.
lands in here
A square sticky note: 3 inches, exactly — same as the ceiling of what fits, on the rail or off it.
The classic square is exactly 3 inches on a side — a fact about sticky notes, and it happens to be the exact ceiling of what fits.
Bar top, coffee table, wherever the pad lives — look at the bottom, not the rim. Tallboys and pint glasses taper; the base is the only measurement that decides it.
Base sits inside the square? It fits. Hangs over the edges? Too wide. A tiny puck lost in the middle — under 2 inches? Too narrow.
No ruler at the poker table, no guessing at the rail. One sticky note off the pad by the bar, and you know before it's your shot.
Fit check
The bottom inch decides what fits the room.
The rule is one line: a container base 2 to 3 inches across settles in. Every verdict below follows from it.
- 12 oz beer can fits
- 16 oz tallboy fits
- Bottled beer fits
- Pint glass fits
- Red Solo cup fits
- 40 oz Stanley-style tumbler fits
- Energy drink, 16 oz fits
- Energy drink, slim 12 oz fits
- Whiskey rocks glass fits
- Coffee mug, handled handle in the way
There's a floor as well as a ceiling — the slim 12 oz energy can sits near the low end, and anything narrower starts to feel lost in the base. The mug is the honest exception here too: the base fits, but the handle lands exactly where a fin needs to grip.
The full fit database — Stanley, Red Bull, Yeti, and 30 more, with sourced base measurements →
Other routes
Compared to what the room already has.
| A poker table's built-in cup holder | The Game Room Cup Holder | |
|---|---|---|
| Which drink size actually fits | One size, fixed when the table was built | Grips a can, a tumbler, or a glass alike |
| How deep the cutout really is | Shallow on budget tables — a full glass tips out | Fins grip the bottom inch and hold steady |
| Getting one onto the table | A hole cut into the rail, for good | Sets down on top — nothing cut, nothing bolted |
| When players shift seats | Fixed to one spot on the rail | Sits wherever you're actually seated |
| Away from the poker table | Stays behind — built into that one table | Comes along to wherever the game moves next |
| A full table, every seat playing | One per built-in seat, nothing for extra guests | One per player, as many as are playing |
| Cost | Already there if the table came with one | One small piece, worth it for the room |
They mean cutting holes in the table and committing to one diameter for good — standard cutouts take a can but not a rocks glass or tumbler, and owners of the jumbo size report regular cans loose enough to rattle and tip. Budget tables' recessed holders run shallow enough that drinks go over anyway.
Reviewers report the same short list: too small for a real cup or tumbler, a grip that only holds within one narrow edge thickness, and enough failures that owners add velcro and anti-slip pads just to keep the holder itself attached. Pool-table communities warn that cranking the clamp bracket too far snaps it.
Praised right up until the practical caveats — they eat floor space in a room already sized to the inch around the table, and players report drinks going over when a chair slides back into a cart nobody saw behind them.
The zero-cost fix every table owner tries: drinks stay three feet back, coasters on the rail, a fine for breaking it. It works on the person who paid for the felt — forum veterans say it reliably fails on the guests who didn't.
Function
The mechanics behind staying put mid-game.
A cushion, a carpet, even a padded poker rail all give a little under weight — a narrow base rocks on any of them. The wide, low base lies across the surface instead of balancing on one spot of it.
Flexible fins hold the drink by its bottom inch from the sides, so a can or glass can't rattle loose when the table gets bumped or the couch shifts underneath it.
A cue swings, a chip stack slides, someone leans off the couch to make a shot — the low, wide base rocks with whatever it's sitting on and brings the drink back level.
Why more than one
Two tallboys. Whose is whose?
Five guys, five identical tallboys pulled from the same cooler — by the second round nobody's sure which one they set down on the rail. Somebody grabs the wrong can, or worse, nobody claims theirs until it's flat and forgotten by the felt.
Build your set
Give everyone their own.
Pick a pack, then give each one a color — so nobody has to ask which drink is theirs.
From the reviews
What buyers say.
Real reviews of the Steadi — these ones mention game life.
I have a tendency to spill my drinks and have two cats. This is one of the best things I’ve ever impulse bought. It works. It actually works. It’s a heavy, wide enough base that it is actually stable. My “spot” in the living room is near a somewhat-cushioned fabric ottoman, which is where I usually put my drinks. It’s
Dixie · 2026-08-30Keeps our drinks safely upright..even room for a coaster underneath. Company was diligent in working out a small issue with delivery and answered communication quickly to resolve the problem. Thank you.. I would order again
Krista M. · 2026-05-30Every Friday is game night on the floor at our house and almost every Friday something spills. Not anymore. Thank you Steadi!
Felisha G. · 2026-05-27Got the 4-pack and immediately put one in every room. Office, kitchen, living room, bedroom. They live there now. Best decision.
Brian M. · 2026-05-27All 119 reviews are for the drink base itself, collected across every place people use it.
Know the room
Six surfaces in this room, and every one of them already belongs to the game.
The reason drinks fail in here isn't carelessness — it's that every surface in the room exists to serve a game first, and a drink second, if at all.
The wooden rail is the only ledge within a shooter's reach, and the cloth six inches away is tightly woven wool that soaks up a spill instead of shedding it — stiffened for good, not just stained. Billiards guides call spillage the top reason felt gets replaced.
The rail ringing the felt is built for chips first; where it does carve out a cup holder, it comes in exactly two sizes — standard, which won't take a rocks glass, or jumbo, loose enough that a can rattles and walks.
Soft pile hides a can at ankle height, right in the walking lanes players circle during darts, foosball, and pool. It's the default drink spot for every standing game in the room.
Cushions tilt with every shift in weight, and a clutch round means sudden movement — the drink ends up wedged against an armrest or set on the floor below, closest to whatever's charging.
Rods slam and cabinets vibrate under their own hardware, so anything set on the edge walks on its own — directly above the electronics and directly under the fastest hands in the room.
The one surface in the room actually meant for a drink — and it's against the wall, a room-crossing away from the table, the dealer, or the couch. Drinks migrate back to the rail and the racetrack because that's where the game is.
Why drinks go over in a game room — and what actually holds one steady — the full story →
Before you buy
Asked between rounds, answered here.
Does it actually work on a pool table rail?
That's the whole reason it's shaped this way. The wide, low base spreads across the wooden rail instead of tipping on the narrow lip, and the fins keep a can from sliding toward the felt when someone leans in for a shot. It resists tipping — it doesn't replace the house rule of keeping it off the cloth itself.
My poker table already has cup holders — do I need this?
Depends which size you got. Standard cutouts don't take a rocks glass or tumbler, and jumbo ones leave a regular can loose enough to rattle. This holds either size, drops in anywhere on the racetrack or the rail, and moves to whichever seat you're actually sitting in.
Will my tallboy or tumbler fit?
Measure the bottom, not the rim. A base of 2 to 3 inches across fits — the 40 oz Stanley does, and so does a standard can or tallboy. Handled mugs don't; the handle lands right where a fin needs to grip.
Does it damage the felt or the table finish?
No — it doesn't touch the felt at all. It sits on the wooden rail, the racetrack, or off the table entirely, so the drink never has a reason to be over the cloth in the first place.
Does it clamp onto the rail or the table edge?
No. Nothing gets clamped, drilled, or bolted on. It sits on top of whatever surface is closest and comes with you when you move to the next game.
What about the carpet by the table?
Same base, same grip — it works at least as well on hard, flat surfaces as it does on carpet or a cushion. Set it down in the walking lane and a bumped drink is far less likely to go over or walk off.
Does it work on the gaming couch too?
Yes — that's soft, uneven, moving ground, which is exactly what the base is built for. Its low, wide weight rocks with the cushion instead of tipping on it, so a long session doesn't mean holding a drink one-handed for hours.
How do I clean it after a spilled energy drink or beer?
Rinse it, wipe it down, or put it in the dishwasher. It's one piece of flexible material with nothing to unscrew or take apart, so the sticky stuff has nowhere to hide.
Who makes it, and where do I buy one?
It's called the Steadi, molded in small runs in Orange, California by Steadi Labs. Every order ships free from steadilabs.com, with 90 days to change your mind.
Ninety days of real game nights.
Run it through a month of game nights. If it doesn't do what this page says — on the rail, on the couch, in your hand — email hello@steadilabs.com and it gets made right. No forms, no fight.
Veteran-founded · Patent pending · Made in Orange, California
Save the felt for the game.
The drink stands on the rail, the racetrack, the couch arm, or the carpet by the dartboard — never on the felt, never in anyone's swing.
Stock the game room — ships freeCheckout is on steadilabs.com — Steadi Labs is the company that makes it.